Conneting NetApp with LACP to Cisco

How To configure EtherChannel

EtherChannel it is a way of combined two physicial Ethernet ports  to act as a single logic port.

In this example below  NetApp Filer will be connected to Ports GigabitEthernet 0/41 and GigabitEthernet 0/42, the switch is configure to    NetApp Filer is configured to work in Load Balance using LACP.

 

 

 

10.40.1.49

———-

 

interface Port-channel1

 description ** GoTo Upper netApp – 10.40.1.49 **

 switchport access vlan 101

 switchport trunk encapsulation dot1q

 switchport trunk native vlan 101

 switchport mode trunk

interface GigabitEthernet0/41

 shut

 switchport access vlan 101

 switchport trunk encapsulation dot1q

 switchport trunk native vlan 101

 switchport mode trunk

 speed 1000

 duplex full

 channel-group 1 mode active

 spanning-tree portfast

 no shut

 

 

interface GigabitEthernet0/42

 shut

 switchport access vlan 101

 switchport trunk encapsulation dot1q

 switchport trunk native vlan 101

 switchport mode trunk

 speed 1000

 duplex full

 channel-group 1 mode active

 spanning-tree portfast

 no shut

 

end

 

כתיבת תגובה

צריך להכנס למערכת בשביל להשאיר תגובה.